Fiberglass cable tray elbow mounting method

Fiberglass cable tray elbows should be supported at each end and at intermediate points using brackets or hangers that allow for proper load distribution and longitudinal movement, following NEMA VE 2 guidelines.Support and Mounting PrinciplesFiberglass cable tray elbows require adequate support to prevent sagging, stress, or damage to the tray and cables. Supports should be installed:At each end of the elbow where it connects to straight tray sections.At intermediate points if the elbow spans a long distance, typically following the manufacturer's recommended spacing based on tray width and load capacity .Using brackets, hangers, or clevis supports that are compatible with fiberglass material to avoid cracking or deformation .Installation StepsSelect the proper elbow size based on the tray width and cable fill requirements.Position the elbow so that it aligns with the incoming and outgoing straight tray sections.Attach supports at the ends of the elbow using bolts or clamps designed for fiberglass trays. Ensure that the fasteners do not overtighten, which could damage the fiberglass .Install intermediate supports if necessary, maintaining a maximum span as recommended by the manufacturer or NEMA VE 2 standards.Allow for longitudinal movement by using guides or expansion connectors, especially in outdoor or long-run installations, to accommodate thermal expansion .Bonding and grounding: Ensure that all fiberglass tray sections, including elbows, are bonded together using bonding jumpers if required by the electrical design, even though fiberglass is non-conductive. Grounding may be necessary for metallic fittings or cable shields .Additional ConsiderationsLoad capacity: Verify that the elbow and its supports can handle the weight of the cables, including any future additions.Cable bend radius: Maintain the minimum bend radius for cables as they pass through the elbow to prevent insulation damage .Environmental factors: Fiberglass trays are corrosion-resistant, but supports and fasteners should also be compatible with the environment to prevent corrosion or mechanical failure .Compliance: Follow NEMA VE 2 and NEC guidelines for spacing, support, and installation practices to ensure safety and reliability . By following these mounting methods, fiberglass cable tray elbows can be installed securely, maintaining structural integrity and ensuring safe cable management.